|
TIMING
AND COUNTING LAPS
The display should initially be showing
00’00’.oo. Press button to start the timer. The display will show
running time. When the first lap is completed, press button to record
the first LAP time. The display will show briefly the lap number
completed and flash the lap time for 10 seconds to allow the user to
check the LAP split time. After 10 seconds the display will return to
running time. Press button to record the next LAP time, and so on. If
button is pressed within 10 seconds from the last press, the next LAP
time will be displayed without displaying previous lap time. The
Moto-Trainer can only store the first 100 Laps in memory, however,
statistics for average, fastest, slowest, and total lap times remain
accurate for up to 999 laps.
STOP/SUMMARY MODE/RESET
Press and hold button
for 3 seconds to finish the timing your moto and to go into the SUMMARY
mode. The display will show the TOTAL MOTO TIME and TOTAL LAPS. Press
button to show the AVERAGE LAP time. Press button again to show the
FASTEST LAP time and FASTEST LAP number. Press button again to show the
SLOWEST LAP time and SLOWEST LAP number. Pressing button repeatedly
after this will show the individual LAP times starting from LAP 1
through the last LAP, then return to TOTAL TIME. Press and hold button
for 3 seconds in the SUMMARY mode to RESET the timer, and the display
will once again return to zeros. But be careful, because when you reset,
all lap memories will be erased!
INSTALLING THE MOTO-TRAINER
The Moto-Trainer is designed to be mounted between the left grip
and clutch perch on the handlebar. If there are any attachments in this
area such as a kill switch or hot start it will need to be relocated
elsewhere on the handlebar. Clean mounting area on handlebar with
rubbing alcohol and allow to dry. Expose adhesive back of included hook
Velcro strip and wrap Velcro completely around handlebar ¼ inch away
from grip. Velcro Moto-Trainer on handlebar in location where the
display is easily read and users thumb can access button without
removing hand from grip. Strap down timer when in desired position.
CARE
OF YOUR MOTO-TRAINER
WATER-RESISTANCE
The Moto-Trainer can
withstand contact with water during normal riding and washing, but not
pressure washers. Remove Moto-Trainer when cleaning bike with high
pressure stream of water.
CLEANING
After use, please
rinse the Moto-Trainer with fresh water to remove all dirt and debris
and dry with a clean cloth before storage.
TEMPERATURE
Do not leave your
Moto-Trainer in direct sunlight or in very high temperatures for a long
time, or the display may become black. Do not leave your Moto-trainer in
very low temperature as this may cause a slight time loss or gain. In
both cases the above conditions will be corrected when the Moto-Trainer
returns to normal temperature.
CHEMICALS
Do not expose your
Moto-trainer to solvents such as gasoline and alcohol, cleaners, paints,
etc., as they may cause damage to the Moto-trainer.
BATTERY CHANGE
When the display becomes dim or turned off, battery
replacement is necessary. We recommend that you go to your dealer or a
qualified technician. Replace with Lithium battery CR1616 or equivalent.
|
